Enhancements for Other Reloading Presses
CNC Pro Chucker 7 Die Plate (SKU: T1595)This Die Plate for the RCBS Pro Chucker 7 reloading press is CNC Machined to precise tolerances from 6061-T6 aluminum. The die stations are threaded to a Class 2B fit. The die plate is solid, over 1" thick and flat on the bottom ... making it much stronger with less flex than a cast die plate.
||Loaded Round Counter (SKU: T1555)The UniqueTek Loaded Round Counter is an electronic counter for your Dillon press that counts only successfully loaded rounds ... not just press cycles. Can also be used on many other reloading presses that have: 1) Have a Crimp Die with an open top, and 2) Have a primer tube or similar place on which to mount the LCD Display Module.||Powder Through Expanders (SKU: T1580)If you use the Mr. Bulletfeeder on a Hornady Lock-N-Load® AP™ press, you'll want one of these redesigned Powder Through Expanders (PTX™). The dimensions of the expander tip have been optimized for use with the Mr. Bullerfeeder bullet dropper. Some guys find it works better than the original Hornady PTX™ … even without a Mr. Bulletfeeder.||Primer Tube Stand (SKU: T1567)The UniqueTek Primer Tube Stand holds up to 12 primer pickup tubes, 6 on each side, in a horizontal position. The Stand has a base that is wide enough to be stable and not easily tipped over. It assembles in just seconds and can easily be dismantled to save bench space when not in use.|
|RCBS Die Wrench (SKU: T1560)The best and last die wrench you'll ever need for 1-3/16″ RCBS die lock rings.Box ends for maximum strength. Thin walled to easily fit between closely spaced dies. Double-ended to fit both 1-3/16″ and 1-1/8″ Die Lock Rings ... so it also fits the closely spaced 1-1/8″ die lock rings on Dillon presses and on LEE Pro 1000 and LEE Load Master progressive presses.||The Bin-Dam (SKU: T1359)The Bin-Dam™ fits into the front of the Cartridge Collection Bin for Dillon, LEE and RCBS reloading presses. It keeps rounds from rolling out and onto the floor when the bin gets near full. Allows use of 100% of bin's capacity. Available in three sizes to fit the cartridge collection bins for SDB/550/650 presses, the 1050 press, and for the SL 900 Shotshell Loader.|