bore-tips

 
Gun-tips

How to Use Bore-tips®
how to clean bore-tips
1. Use a Bore-tip to apply the solvent to the barrel.
2. Allow the solvent time to work.
3. Brush the bore to break up any fouling.
4. Use a clean Bore-tip to push the fouling out of the bore. When the now dirty Bore-tip clears the bore, wet it with a little solvent and then squeeze it with an absorbent rag or paper towel, this will blot the dirt off. After blotting the Bore-tip should be clean enough to continue using to remove the fouling until you are finished cleaning.
5. When you are satisfied with the cleanliness of your barrel, use a clean Bore-tip to dry the bore.
6. If you wish to lubricate use another clean Bore-tip to apply lubricant.

PLEASE NOTE: Always make sure the firearm is unloaded before cleaning. If you lubricate the barrel it must be dry swabbed before it is fired again. The bore should ALWAYS be clear and dry before firing.

How to Clean Bore-tips®
how to clean bore-tips
Using Mineral Spirits: For faster cleaning use mineral spirits. Apply mineral spirits to the Bore-tip and squeeze/blot into an absorbent rag or paper towel. When the Bore-tip is clean let dry and reuse.
Using Soap and Water: Squeeze to blot out any excess solvent or dirt. Next, wash the Bore-tip with a grease cutting soap and warm water. Once clean, rinse then let dry completely.