 |
| Click to enlarge image(s) |
Design & Operation
The design is a very simple "piggy-back" of a rugged light-weight Delrin® lever, with a longer bolt catch roll pin (included) as a pivot axle. The lever only contacts the top of the bolt catch, floats on the new roll pin and extends down towards the front of the trigger guard. The lever requires a definite motion to release the bolt (for safety purposes) but can be released with just a press of your trigger finger.
Great for "Match Rifle" Use!
Extended bolt release levers are great for Match Rifles/Spaceguns ... especially if you have a side cocking upper!! Rapid fire strings are easier!
"Service Rifle" Rules Now Allow an Extended Bolt Release!
Section 4.1.1 M16/AR15-Type Service Rifle.
b) ..."An extended bolt release is permitted on both right and left-handed receivers, provided there are no permanent alterations to the upper or lower receivers."
i) ... "Extended both releases must be attached on the original manufactured side of the lower receiver."
To read the complete CMP Highpower Rifle Competition Rules 23rd Edition—2019, Click Here.
Installation
Installation is easy and does not require a gunsmith. Just drive out the existing bolt catch roll pin (to the rear), leaving the punch in place. Drive the new roll pin (with lever attached) forward, stopping when pin just protrudes from the forward edge of attachment point. The pin is flared at the engraving end to retain the lever.
♦ If you don't already have the special flat-sided punch needed to remove the roll pin, we now stock one! Just Click Here!
The photo below shows the Bolt Release Lever installed on an AR-15 lower.
♦ The AR-15 Extended Bolt Release Lever works great in conjunction with the "Original Bob Sled" AR-15 Single Shot Loading Device.
| Delrin is a registered trademark of E. I. du Pont de Nemours and Company. |  |
See Also
Submit a Review...